Smart Videohub ethernet control

Questions about ATEM Switchers, Camera Converter and everything live!
  • Author
  • Message

  • Posts: 2
  • Joined: Mon Mar 05, 2018 10:46 pm
  • Real Name: Adam Kelley

Smart Videohub ethernet control

PostTue Mar 06, 2018 6:04 pm

I'm using an Extron IPCP Pro control processor which shows that it is connected to the Videohub, but it will not accept any matrix tie commands. I've tried both "client" and "server" on the switcher, enabling and disabling "take", using RS422 over ethernet driver, and using "regular" ethernet drivers.

The bottom line is that the control processor "sees" the Videohub just fine but the videohub won't take commands.

I am sure they are talking because the status is accurate - if I pull the Videohub off the network, the control processor reports disconnected and when I put it back on the network it reports connected.

Any help is appreciated.



Return to Live Production

Who is online

Users browsing this forum: John Kane and 3 guests