Super source qs

Afternoon gents and ladies

I’ve created a couple of macros that switch between different studio sets all setup as super sources

Camera 1 has all graphics etc and set to cam 1 supersource
Camera 2 the same but set to cam 2 supersource

Both switch no problems however I’ve been asked to run transitions between each switch
Which I can’t do as am switching between one supersource to another is there a way around this

Thanks

there's only one super source, so no you can't transition between your two presets.

you MIGHT be able to program a macro with many steps that change between your two setups, sort of like an animation. Really depends on how complex your presets are, hard to say without seeing your 2 looks. post a shot of each and maybe we can offer better suggestions.

another possibility is to use an external device like the MD-QUAD to fake a super source setup outside of the ATEM, and then transition between the internal SS and the external fake SS.

one last thought...are you just trying to change the cam in the SS box with everything else the same? if so, put ME2 in the box and transition your cam there