Mon May 21, 2018 12:56 pm
Hello BMD users,
I installed the 7.4 software to update an ATEM 2 M/E but the ATEM setup software says to use 7.3 because 7.4 doesn't support this model.
So I installed 7.3 and firmware update was made over ethernet, but in USB mode, to change the ATEM IP address, the driver doesn't complete the installation so there is no USB connection.
So to have all compatibility I'm coming back to 6.3 where all works without problems.
Question; what is the last version that supports the ATEM 2 M/E?
Best Regards,
Paolo