Wed Feb 26, 2020 10:44 am
I have not performed this in the past. We use the Iris control in the camera as this is just so much easier. Also gets controlled from the Atem Set so we can adjust all cameras properly.
But Basically you add pin 5 to the Wiper of a 50K or 100K potentiometer, And 1 of the ends to the GND pin. (3) And that should do the trick. Do not connect the other pin of the potentiometer. The power is applied from pin 5.
I'm not liable for any damage if you perform this without knowledge about electronics. And would advise you to find somebody in the neighborhood which is an electronic savy.. The hirose 12 is very difficult to solder if you have no expert knowledge about soldering.
Also before hooking everything up.. Just Measure it with a multimeter to check the connections once more.
Daniel Wittenaar .:: Xtreemtec Media Productions ::. -= www.xtreemtec.nl =-
4K OBV Trailer, ATEM TVS HD, 4M/E Broadcast Studio 4K, Constelation 8K, Hyperdeck Studio 12G, Ursa Broadcast 4K, 4K fiber converters with Sony Control