ATEM TV Studio - no multiview out (SDI or HDMI)
Posted: Tue Aug 21, 2018 7:45 pm
I have been using our ATEM TV Studio, along with the hardware panel, with good success until recently. In the past week, we have lost the ability to get a multiview output from either the SDI or HDMI output ports. I have upgraded the ATEM software to the current 7.5.2 release.
I unplugged the ATEM (it is normally running 24x7) and let it cool down for a couple of hours with no difference in the results.
Is there anything that I can try to get this working again?
Thanks
Bill
I unplugged the ATEM (it is normally running 24x7) and let it cool down for a couple of hours with no difference in the results.
Is there anything that I can try to get this working again?
Thanks
Bill