20x20 video Hub/ SDI to HDMI micro convertor
Posted: Wed Sep 05, 2018 12:05 am
Hi All,
Having an issue with one of my projectors. I run a 3 projector setup on Sundays, center input always stays the same but have a need to change the video input on left and right projectors thru the video hub during services. my problem comes when I use the video hub software to change the input from camera to media pc, the left changes ok with a slight flicker, the right however is a 50/50, sometimes it's a quick flicker other times it takes about 3-5 seconds or more to change causing a noticeable distraction. my setup is Atem switcher SDI out to video hub then SDI to BM micro converter to hdmi projector. the projector is set to HDMI input, same as left. it's like it loses the HDMI lock and takes a few to regain. Thoughts?
Having an issue with one of my projectors. I run a 3 projector setup on Sundays, center input always stays the same but have a need to change the video input on left and right projectors thru the video hub during services. my problem comes when I use the video hub software to change the input from camera to media pc, the left changes ok with a slight flicker, the right however is a 50/50, sometimes it's a quick flicker other times it takes about 3-5 seconds or more to change causing a noticeable distraction. my setup is Atem switcher SDI out to video hub then SDI to BM micro converter to hdmi projector. the projector is set to HDMI input, same as left. it's like it loses the HDMI lock and takes a few to regain. Thoughts?