Audio to SDI mini converter, on channel 3 and 4

Hey

I am running a ATEM TV studio HD that embeds 2 channels of audio on the SDI output.
My question is if it is possible for the Audio to SDI mini converter to keep audio from channel 1 and 2 on the SDI input, and then embed additional audio on channel 3 and 4 from the connected jack inputs on the converter.

So that on the SDI output from the converter we keep the original audio on 1 and 2, but add additional audio on channel 3 and 4.

Yes, this should be possible using the mini switches on the side of the Audio to SDI Mini Converter. Switches 1 to 4 are used to selectively enable or disable audio embedding from each of the 4 audio inputs on the converter.

Any channels for which embedding is disabled will pass through the audio from the SDI input.

So if using analog inputs, I think you would set the switches as follows:

• Switches 1-2 to ON (disables embedding for channels 1 and 2)
• Switches 3-4 to OFF (enables embedding for channels 3 and 4)
• Switches 5-6 to OFF (selects SDI audio channels 1-4)
• Switches 7-8 to OFF (uses analog input and sample rate conversion)