Dead Channel 1 Atem 1

Thanks for the add, been using the forum and videos on setup, for a while now but now I have an issue.
Since upgrading to the new software and getting it all working I've now lost input 1 - HDMI on my Atem 1 M/E production Switcher, it was there before the upgrade and even showed MAC inputs which it does not do now, but that's another issue. Everything matches and I have inputs all working on the other 7 inputs. If I re-route say MP1 to channel 1 this does not show on the pre view list either, but only on channel 1. It still switches and shows the image from MP1 but no preview.
cheers
malcolm

[Gary Adams]

Hello Malcom. In the Software File -> Configuration Menu -> Labels Tab. Make sure input #1 is set to HDMI. It may have reverted to SDI.

Regards, Gary