ATEM TVS FAULTY
Posted: Thu May 16, 2013 2:17 am
Hi all,
I have recently purchased the ATEM Television studio off Amazon and had the unit shipped to New Zealand my problem is port 3 the SDI/HDMI depending on what you select is dead. I have change the software options and have used ATEM firmware 3.3, 3.4 and 3.5 with no luck.
Have any other users experienced this? and do you have a possible solution?
Can I get this repaired anyway without having to send the unit back to America?.
I have recently purchased the ATEM Television studio off Amazon and had the unit shipped to New Zealand my problem is port 3 the SDI/HDMI depending on what you select is dead. I have change the software options and have used ATEM firmware 3.3, 3.4 and 3.5 with no luck.
Have any other users experienced this? and do you have a possible solution?
Can I get this repaired anyway without having to send the unit back to America?.