For all you Grass Valley ATEM panel users....
Posted: Wed Jan 09, 2019 7:47 am
I am about to release a major upgrade that allows these panels that have been modified for ATEM control to work with ATEM firmware v7.5.2 (and hopefully above).
This has required a major rework of the communications protocol and has enabled a much faster connection and re connection time amongst other things. I have basically redesigned the comms from the ground up! There will be NO need for any change in the current hardware that is being used.
I will shortly be sending out emails to all licensed users with instructions on how to acquire and install GVG2ATEM v3.00. My other devices will follow shortly.
Baz
This has required a major rework of the communications protocol and has enabled a much faster connection and re connection time amongst other things. I have basically redesigned the comms from the ground up! There will be NO need for any change in the current hardware that is being used.
I will shortly be sending out emails to all licensed users with instructions on how to acquire and install GVG2ATEM v3.00. My other devices will follow shortly.
Baz