- Posts: 32
- Joined: Thu Mar 07, 2013 10:14 am
- Location: sydney
Hello,
you need the Blackmagic GPI and Tally Interface to connect to Datavideo ITC100.
http://www.blackmagicdesign.com/product ... io/models/ (down the page)
Then go to Datavideo Homepage:
http://www.datavideo.info/en/Intercom%20Systems/ITC-100
and download the maunal for ITC100.
On page 12 Datavideo describes the ITC100 Tally Input Pin Cross Reference.
As appendix an picture from the Blackmagic GPI and Tally Interface.
You see its PIN Reference.
Then you should buy an matching plug for the Blackmagic GPI and Interface and an matching plug for the ITC100 Tally.
Than you solder an cable from the Red LED LIVE (On Air) suitable PINs on the ITC100 Tally Plug to the suitable PINs on the Blackmagic GPI and Tally Interface!
This is handmade!
Dont forget to solder Ground!
There is no Preview/Next/Cued/ Info available on the Blackmagic GPI and Tally Interface....
Hope it helps.
Ask me, if you have another Question.
best regards
Andreas