- Posts: 1
- Joined: Thu Apr 06, 2017 5:23 pm
The panels have a 1 on 1 routing system So select destination. Then select source and take.
For "macros" you could shoot off a text based Channel selection trough telnet.
The gpio boxes Im not Sure off..
EDIT:: I was wrong this time.. Sorry guys.. Got an Email from Hersh Burston
Our Videohub range support Macros via our Blackmagic Smart Control panel.
You can assign 10 Macros buttons each of which can do up to 16 crosspoint switches.
Text based telnet commands can also be used but not as straight forward to program.
GPI and Tally interface can switch crosspoints based on contact closure and there are only 8 available. This can be increased by connecting more units onto the network.
You could use the automation system to send the 16 switches or if the automation system supports contact closure then GPI and Tally is the only way to do this as it can’t access the Smart Panel.
So Macros ARE possible