Hello,
I am currently setting up eight brand new MacPro systems to work with Premiere CS6, using 1080p25 monitoring via HDMI from the Intensity Pro. I have not been able to get any video output from HD progressive sequences, interlaced HD and SD sequences work properly.
The Intensity outputs 1080p sequences properly within Final Cut Pro 7 and After Effects. Audio is working out of the card within Premiere even when the video is not working. If the card is set to down convert HD progressive sequences and output via either HDMI or s-video, I run into the same problem.
I googled this issue and noticed that others have had similar problems when upgrading to the 9.7 drivers, so I've tried rolling back to to every driver down from 9.7 to 9.6 but this had not helped. I have tried using the Blackmagic sequence presets, but normally I need to be using the AVCHD 1080 25p presets (it's a little unhelpful that no 25p Blackmagic presets are provided, but I am sure this isn't the issue anyway). I am testing with colour bars generated within the project in Premiere.
I am very familiar with the Intensity cards and drivers as we've been using these for down-converted SD monitoring from FCP for the last few years. Sadly we can't switch over to our new systems to use Premiere until this has been resolved.
Could someone please advise?
Regards,
Paul
System Spec:
MacPro 5,1
2x 2.66 6-core Xeon
24GB Ram
ATI 5770
NVidia Quadro 4000
Mountain Lion 10.8.2
Premiere CS6 (6.0.2)
Video Desktop (9.7 - 9.6 tested)
I am currently setting up eight brand new MacPro systems to work with Premiere CS6, using 1080p25 monitoring via HDMI from the Intensity Pro. I have not been able to get any video output from HD progressive sequences, interlaced HD and SD sequences work properly.
The Intensity outputs 1080p sequences properly within Final Cut Pro 7 and After Effects. Audio is working out of the card within Premiere even when the video is not working. If the card is set to down convert HD progressive sequences and output via either HDMI or s-video, I run into the same problem.
I googled this issue and noticed that others have had similar problems when upgrading to the 9.7 drivers, so I've tried rolling back to to every driver down from 9.7 to 9.6 but this had not helped. I have tried using the Blackmagic sequence presets, but normally I need to be using the AVCHD 1080 25p presets (it's a little unhelpful that no 25p Blackmagic presets are provided, but I am sure this isn't the issue anyway). I am testing with colour bars generated within the project in Premiere.
I am very familiar with the Intensity cards and drivers as we've been using these for down-converted SD monitoring from FCP for the last few years. Sadly we can't switch over to our new systems to use Premiere until this has been resolved.
Could someone please advise?
Regards,
Paul
System Spec:
MacPro 5,1
2x 2.66 6-core Xeon
24GB Ram
ATI 5770
NVidia Quadro 4000
Mountain Lion 10.8.2
Premiere CS6 (6.0.2)
Video Desktop (9.7 - 9.6 tested)
www.chief.tv
www.paulwilliscolour.com
AMD Threadripper 3970X 32-Core
RTX 3090 24GB
128GB RAM
Windows 11
www.paulwilliscolour.com
AMD Threadripper 3970X 32-Core
RTX 3090 24GB
128GB RAM
Windows 11