- Posts: 205
- Joined: Tue Nov 07, 2017 8:45 pm
- Location: North Kingstown, RI USA
Hi Ric hope you are enjoying your UMP.
1) As it is RAW the white balance setting can be re-adjusted in post without any issues as it is non-destructive but it does effect what people see when they first look at the footage so if you are handing the footage off to someone it's good to get it close so you have a good starting point. It also makes it quicker in the grade if your white balance is already set. The easiest way to do this is to do an auto white balance off a grey or white card with the lighting conditions that you are using to get you a good neutral white starting point.
2) The Flanders probably does't take a 2160p signal on the SDI input.
If you are shooting at Ultra HD resolution or above the camera defaults to sending 2160p out from the Main SDI output. Hit the 'Menu' button and go to MONITOR > Main SDI and then swipe across to the second page. You will have the option of 2160p or 1080p from your Main SDI output. Change it to 1080p this should fix your issue.
As a side note you will always have the option of progressive and if you are shooting at 50p, 59.94p or 60p you will also get the option to send an interlaced 1080i signal out from the Front & Main SDI outputs.
Hope this helps.