Fri Feb 16, 2018 12:48 pm
videokadr wrote:I discovered one more possibility to connect SONY RMB150 control over PTZ. The PTZ transmits signals RS422 like as RMB 150 Sony. It is enough to properly connect the wires to the connector and the control of SONY camera parameters should be work. I will check it out next week.
I can tell you right now it wont work.....
Unless they changed the protocol settings for the RMB150..
Yes Sony is a 422 serial protocol. But at such high baudrate the Visca port will not understand it at all... (more then 10 times faster then the Visca protocol) Also the PTZ port is only taking visca commands! As it does take the Visca commands it does know and does embedd this into the SDI data stream with the commands listed in the SDI protocol that is at the end of the manual of the Ursa.
I have been working on the Sony protocol and have written permision under NDA so i know what it takes to communicate with sony cameras.
Daniel Wittenaar .:: Xtreemtec Media Productions ::. -= www.xtreemtec.nl =-
4K OBV Trailer, ATEM TVS HD, 4M/E Broadcast Studio 4K, Constelation 8K, Hyperdeck Studio 12G, Ursa Broadcast 4K, 4K fiber converters with Sony Control