Sander de Regt wrote:What happens if you render only 1 single mov? Does it still crash?
Because in your example there are a lot of savers.
Yes, that was just an example of a simple comp where it crashes. I can literally get it to crash with just a single loader and a single saver in fresh new comp.
Honestly, people repeatedly asking about different conditions is getting a bit old. There is one common factor that causes ANY comp to crash REGARDLESS of it's contents, setup or complexity. That common factor is a saver that is set up to export H264 mov. That is it.
No, amount of savers does not matter.
No, there are no other specific nodes causing the crash.
No, Fusion 8 does not crash in H264 export.
Yes, Fusion 9 crashes in 100% of the cases.
Yes, I do have latest GPU drivers.
Yes, I did try to install ffMPEG codecs.
Yes, I did try to install quicktime.
Yes, I did try to uninstall Fusion 9, remove all the saved preferences and reinstall it from scratch.
Yes, I did test it on another computer, still crashes.
Yes, I even did try it after a fresh Windows reinstall.
Yes, I did try to set rendering to just one thread.
Yes, I did try to disable OpenCL.
Yes, I did try to other codecs than H264 and none of them crash.
etc...