Hi, Is it normal that the remote focus control via SDI on the URSA 4.6k EF (v4.8) does not work? The command 0.0 works fine on my BMMSC but not on the URSA camera, most other commands seem to work (like 0.2 Aperture). Is this normal behaviour?
Hi Cameron, Thanks for the reply. This bit of code seems to work on a BMMSC on both focus and aperture but on a URSA only aperture works. On my ATEM 1M/E 4K focus and aperture both work on both cameras.
// Enable both tally and control overrides sdiTallyControl.setOverride(true); sdiCameraControl.setOverride(true);
Serial.println("\n\nLet's go..."); }
void loop() { sdiTallyControl.setCameraTally( 2, // Camera Number 1, // Program Tally 0 // Preview Tally );
delay(1000);
sdiTallyControl.setCameraTally( 2, // Camera Number 0, // Program Tally 1 // Preview Tally );
for (float Value = 0; Value < 1; Value += 0.05 ) {
sdiCameraControl.writeCommandFixed16( 2, // Camera Number 0, // Lens 0, // Focus 0, // Index Value // Value ); Serial.println(Value, 3); delay(100); }
for (float Value = 0.5; Value >= 0; Value -= 0.05 ) {
sdiCameraControl.writeCommandFixed16( 2, // Camera Number 0, // Lens 3, // Aperture 0, // Index Value // Value ); Serial.println(Value, 3); delay(100); } }