Loop selection reset color page

Once I set a range of clips to loop I can't figure out how to reset loop selection to go back to looping single clip. Not sure if this is a bug or new protocol. From memory it would go back to single clip once loop is turned off.

Once I set a range of clips to loop I can't figure out how to reset loop selection to go back to looping single clip. Not sure if this is a bug or new protocol. From memory it would go back to single clip once loop is turned off.

They changed the way it works in 16, did not tried yet.

In the 15, turning off-on it was going back to single clip

[Dwaine Maggart]

If I'm understanding correctly, multiple clip looping involves setting an In and Out point for the loop range.

To get back to single clip looping, you'd clear the In/Out points with Alt-x.

Or are you using some other method to select the loop range?

option x seems to do the trick!!! (on the Mac)