- Posts: 1
- Joined: Tue Dec 10, 2019 9:52 pm
- Real Name: Jeremy Mitchell
Hi Jeremy,
When the DeckLink Duo 2 and Quad 2 cards are configured with half-duplex profile (ie each connector can be configured as either input or output), there will be a short delay from when IDeckLinkInput::EnableVideoInput is called to when the device locks to the incoming signal.
In addition, if you are using auto-mode detection, rather than specifying the input mode, then there will be a small delay of 1-2 frames.
You can minimize the delay of the captured frame by calling EnableVideoInput in advance and ignore incoming frames until capture is required - perhaps by adding a getchar() to initiate capture.
Regards
Cameron