- Posts: 2
- Joined: Wed Mar 04, 2020 4:42 pm
- Real Name: Gordon Murray
Wed Mar 04, 2020 4:53 pm
Hi,
Just trying to control a Multiview 16 via Ethernet and first test was to switch from mosaic to fullscreen.
This works as expected via:
CONFIGURATION:
solo enabled: true
And you get the ACK back but although the SDI output changes the mini screen stays on the mosaic mimic. As in the mini screen will only change if you physically press 'SOLO' on front of unit.
I tried a firmware update to 2.2 via MV Setup app but unfortunately this fails with at 100% with update failed so not sure if this is fixed in a later version.
As in if I send alternately solo enabled: true and solo enabled: false the mini screen on unit should follow suit as well as actual SDI output following
Just trying to control a Multiview 16 via Ethernet and first test was to switch from mosaic to fullscreen.
This works as expected via:
CONFIGURATION:
solo enabled: true
And you get the ACK back but although the SDI output changes the mini screen stays on the mosaic mimic. As in the mini screen will only change if you physically press 'SOLO' on front of unit.
I tried a firmware update to 2.2 via MV Setup app but unfortunately this fails with at 100% with update failed so not sure if this is fixed in a later version.
As in if I send alternately solo enabled: true and solo enabled: false the mini screen on unit should follow suit as well as actual SDI output following
