Tue May 24, 2022 12:07 am
I tried testing this with a HyperDeck Studio HD Plus and it seems to work:
1) Telnet into device.
2) Send commands:
play on startup: enable: true
play on startup: single clip: true
3) Confirm that device is already in Loop mode. If not, enter the command:
play: loop: true
4) Remove power.
5) Plug in power.
HyperDeck boots up and starts playing the first clip on loop. I was not able to set it to play any other clip.
Developer of MixEffect, the best app for controlling your ATEM switchers using your iPhone, iPad, and Apple Silicon Mac: https://mixeffect.app