- Posts: 20
- Joined: Wed Nov 18, 2015 12:04 pm
- Location: Edison NJ USA
Thu Dec 10, 2015 6:25 pm
Hi
what API i should be using to disable the Relay between Rx And Tx during Capture only mode using the C++ code .
what I have notice if I write a capture only program ( Rx for the device is connected to a source )
and device is configured for Capture mode only , I will see and output on the screen if Tx for that device connected to a monitor .
Regards
Sami Fattah
what API i should be using to disable the Relay between Rx And Tx during Capture only mode using the C++ code .
what I have notice if I write a capture only program ( Rx for the device is connected to a source )
and device is configured for Capture mode only , I will see and output on the screen if Tx for that device connected to a monitor .
Regards
Sami Fattah
sami fattah
Software engineering
Software engineering