Blackmagic Forum

Posted: **Tue Dec 03, 2013 1:29 am**

When I try to adjust the settings on the ATEM Software control I noticed that under video inputs only CAM 3 and CAM 4 are highlighted despite the fact that I don't have a cam 3 or 4. Is this just a default. I can't change anything under the other video inputs. Thoughts?

Posted: **Tue Dec 03, 2013 1:47 am**

3 and 4 are the inputs that can change from hdmi to sdi.
the others can't.
(might be worth reading the manual, rather than posting a million questions)

Posted: **Tue Dec 03, 2013 9:48 am**

Posted: **Tue Dec 03, 2013 7:40 pm**

The manual is long and you guys answer much faster. Thanks

Blackmagic Forum

ATEM Software issue

ATEM Software issue

Re: ATEM Software issue

Re: ATEM Software issue

Re: ATEM Software issue