Wed Mar 15, 2023 2:33 pm
Hello everyone,
I just received my Blackmagic 3G SDI Shield, I soldered on all the pins and plugged it into my Arduino uno R3, I tried to flash, and it just didn't flash, it was stuck on Upload the whole time. When I unplugged the Shield and tried to flash, it flashed just fine.
I then tried to bend the communication pins: A4 & A5 and SCL & SDA, away from the board and plugged it in without it, still didn't flash, then I tried bending away the TX and RX pins and voilà it flashed just fine, but the code wouldn't output to the camera (Studio Camera 4k Pro), so what my question is:
Why does this happen, and how can I fix this? Help would really be appreciated since I'm working on this for the last couple of days with no results.
Greetings, Felix