Sat Feb 15, 2025 12:53 pm
First allow web management/ftp/smb using setup utility 8.6. Then connect to the camera via smb or ftp. The camera, to the best of my knowledge, will not mount as a usb storage device, rather must be mounted as a network drive. After you setup the camera over usb then go to network prefs and you should see the camera network.
To connect use Chrome and navigate to ftp.camsipaddress, use a proper ftp client, mount the network drive, etc., There are a few options to connect once it’s configured. The only hitch I’ve discovered thus far is that ftp transfer didn’t work properly with Safari but this was a firmware and an OS ago.
Good Luck