Blackmagic Forum

Is there a way to extract a lut that was applied to a BRAW file in camera?

Good question.

I’m not sure if you can extract an embedded LUT in BRAW. I do not embed a LUT as a practice. It might present itself as part of the first node in the Color tab that you might be able to just delete. Also if you are using a sidecar, the LUT might be on it and by removing the sidecar or modifying it to remove the LUT information might be how it’s done. Might have to experiment or wait for someone with a definite answer.

Ellory Yu wrote:I’m not sure if you can extract an embedded LUT in BRAW. I do not embed a LUT as a practice. It might present itself as part of the first node in the Color tab that you might be able to just delete. Also if you are using a sidecar, the LUT might be on it and by removing the sidecar or modifying it to remove the LUT information might be how it’s done. Might have to experiment or wait for someone with a definite answer.

It's presented in the Raw tab as an option you can turn on. It's not a node.

ShaheedMalik wrote:

Ellory Yu wrote:I’m not sure if you can extract an embedded LUT in BRAW. I do not embed a LUT as a practice. It might present itself as part of the first node in the Color tab that you might be able to just delete. Also if you are using a sidecar, the LUT might be on it and by removing the sidecar or modifying it to remove the LUT information might be how it’s done. Might have to experiment or wait for someone with a definite answer.

It's presented in the Raw tab as an option you can turn on. It's not a node.

Shaheed, thanks for clarifying that.