What are these artifacts, riddled throughout this clip?
I’ve recently purchased a t7 Shield (new), which is approved on BMD’s list for 6k 50fps at 5:1 BRAW.
After testing, any compression ratio in BRAW at 6k50fps and even 24fps, shows massive amounts of these various colored, rectangle artifacts.
I’ve purchased a USB C 3.2 10gbps cable from best buy that the same issue exists. That isolates the cable issue to now, is this the SSD itself?
If so, I have a T7 shield replacement on the way tomorrow to isolate if it’s the T7 Shield that’s the problem, or a defected product.
My 128gb - 128/mbps SANDISK SD Card can film 12:1 6k 24fps with no frame drop or artifacts, seen on the photos attached here.
I haven’t had the opportunity to get a CFAST card to
test yet.
- IMG_4189.jpg (569.9 KiB) Viewed 207 times
- IMG_4189.jpg (569.9 KiB) Viewed 207 times
- IMG_4189.jpg (569.9 KiB) Viewed 207 times
Sent from my iPhone using Tapatalk