Blackmagic Forum

Hoping someone from the Blackmagic Team is reading this.
I'm running my new Blackmagic Cinema Camera 6K Full Frame on a DJI Ronin RS2 and RS3 Pro.
I'm not able to control the camera through the Gimbal when connected with the USB C Cable.

Firmware of the camera is 8.3.1
Firmware of the Ronin is 01.05.00.20

This issue is the same as in 2021 when Blackmagic updated their Software.
I reached out to DJI and they claim it's a BMD problem.
Older Camera firmwares still work.

This is mostly user forum, did you try contacting BMD directly?


Sent from my iPhone using Tapatalk Pro

DirectedByMarvin wrote:
This issue is the same as in 2021 when Blackmagic updated their Software.
I reached out to DJI and they claim it's a BMD problem.
Older Camera firmwares still work.

Ehm how do you install older firmware on a camera went out a couple of months ago?

If you told about different camera mean different setup… anyway the best will be to contact Blackmagic Design on support page, not to write here.


Inviato dal mio iPhone utilizzando Tapatalk

DirectedByMarvin wrote:Hoping someone from the Blackmagic Team is reading this.
I'm running my new Blackmagic Cinema Camera 6K Full Frame on a DJI Ronin RS2 and RS3 Pro.
I'm not able to control the camera through the Gimbal when connected with the USB C Cable.

Firmware of the camera is 8.3.1
Firmware of the Ronin is 01.05.00.20

This issue is the same as in 2021 when Blackmagic updated their Software.
I reached out to DJI and they claim it's a BMD problem.
Older Camera firmwares still work.

We’re you able to get this said solved, I also got the camera and can’t seem to get it to work with my rs2.

Same issue for me. RS2 camera control works with the 6K Pro when I revert to BM firmware 8.1. But no camera control from Ronin RS2 on 6K FF even after reverting to 8.3.2.

I am experiencing the same issue. The BMCC 6K FF does not work for camera control on the RS2 gimbal. I have tried with my BMPCC4K, and that one works on the 8.1 firmware. Anything newer does not work on the gimbal.

I really hope Blackmagic fixes this in the upcoming stable build of firmware 8.6.

Does anyone know a fix to this? It's so annoying