Page 1 of 1
How to Screw into a Cage
Posted:
Mon Feb 24, 2025 4:33 pmby paulhein
If I want to add something to my cage (enclosing a 4K) I usually have the screw in something like a rod holder. But when it is screwed in tightly, as it needs to be, the configuration is never right. It's always too far one way or the other and never quite where I want it.
You are all far more experienced than I am so how have you solved this?
thanks
Re: How to Screw into a Cage
Posted:
Mon Feb 24, 2025 6:41 pmby rick.lang
Paul, what cage are you using? A closeup picture with your rod holder might be good to see.
Re: How to Screw into a Cage
Posted:
Mon Feb 24, 2025 6:55 pmby paulhein
It’s a smallrig cage. Nothing special about the rod holder - just a standard thread which goes into the cage and a circular clamp for the rod
Re: How to Screw into a Cage
Posted:
Mon Feb 24, 2025 7:28 pmby Johannes Jonsson
Is there a space on the rod holder to use two screws for it?
Re: How to Screw into a Cage
Posted:
Mon Feb 24, 2025 7:30 pmby paulhein
no, the rod holder has a single integral scew
Re: How to Screw into a Cage
Posted:
Mon Feb 24, 2025 7:34 pmby Johannes Jonsson
paulhein wrote:no, the rod holder has a single integral scew
Can you post a picture of that holder showing the base for the screw or a link to that rod holder, I think that´s the only way to speed up possible and more accurate solutions for you