Blackmagic Forum

I purchased the IKAN EP6 battery plate to test if it works.

http://ikancorp.com/productdetail.php?id=336

Unfortunately the DC power connector does not fit in the Blackmagic Socket.

Does anyone know of an adapter that would allow this to fit?

I think it's a a dc coaxial 5mm X 2.5mm type N. I'm assuming it's positive center contact. I'm wiring a P-Tap tonight, I can check polarity then.

I cut the end off an old Iomega Zip drive dc adapter (good wire, heavy plug, right angle) it's perfect.

Isn't that the one that powers Ikan monitors? I think this is what you want:

http://www.bhphotovideo.com/c/product/9 ... Mount.html