- Posts: 99
- Joined: Mon Nov 03, 2014 9:11 pm
Wed Jun 11, 2025 2:34 pm
Hi,
I often change the audio clip attributes from stereo to mono, to ear only the lav mic.
Problem is, when on Source Tape mode in the cut page, I only have sound on the left speaker.
A work around is to simply keep a stereo track with the same embedded channel, but it would be nice to have this sorted out.
I often change the audio clip attributes from stereo to mono, to ear only the lav mic.
Problem is, when on Source Tape mode in the cut page, I only have sound on the left speaker.
A work around is to simply keep a stereo track with the same embedded channel, but it would be nice to have this sorted out.
Last edited by Philippe Metro on Fri Jun 13, 2025 7:53 am, edited 1 time in total.