I'm trying to make a video of a motorcycle ride up a canyon, and mark sites with text that is pinned to the site. The video below is me going by Storm Mountain (ignore the short blackout that happened as a result of my screen capture software). The grid is on along the whole clip, both before and after. I've got the text to come on and go away before and after I pin it to the mountain, but I don't know how to time the grid so that it will come on and off at the same times. I also do not know why It goes wacky at the end of the pinned section as I drive by. I think it is this that is causing rendering to crash. I get between 70% to 80% of the way through rendering each time and DaVinci crashes. As I proceed up the mountain, the grid goes back to normal and follows me up the mountain. I thought it was due to machine resources, so I went out and bought a system with a 6-core processor, 32GB RAM and G-Force engine. Much better viewing and editing, but crashes at the same place.
So, what's going on with the grid and how do I control the timing of it.