Page 1 of 1

Clicking node changes the final image

PostPosted: Sun Apr 05, 2020 11:50 am
by michael_72
After a while in my color grading process, something weird happens: when I click a node, the final image changes and seems to show only that particular node's settings. Clicking the node nest to it changes the image to only THAT nodes settings and so on... Is this something you have heard of before...? Some simple setting I am missing...? I am grading primarily BMPCC4K footage in BRAW and Prores... I have AMD Radeon VII, AMD Ryzen 9 3900X 12-core, 64 GB RAM, Decklink Mini, so I should be good in the hardware department...

Regards, Michael, Sweden

Re: Clicking node changes the final image

PostPosted: Sun Apr 05, 2020 12:49 pm
by Jim Simon
I'm not aware of any method to Solo a node, only to Disable them. You sure that's not what's happening?

Re: Clicking node changes the final image

PostPosted: Sun Apr 05, 2020 7:52 pm
by Kel Philm
Not in front of Resolve so prob off the mark but you haven't left the mask highlight on (Shift H)?

Re: Clicking node changes the final image

PostPosted: Wed Apr 08, 2020 12:39 pm
by michael_72
Kel Philm wrote:Not in front of Resolve so prob off the mark but you haven't left the mask highlight on (Shift H)?


Oh my God, that't it... The mask highlight.... I am so stressed to get a project finished, I didn't realize they were on... Thank You... :)