Page 1 of 1

Help with text please

PostPosted: Sat Oct 17, 2020 11:10 am
by Nigel Scott
Book_2.1.1.jpg
Book_2.1.1.jpg (330.12 KiB) Viewed 321 times


Hi I am trying to make text lie flat on a photo of a book using the Edit page. I have got it not too bad using Pitch and Yaw. But you will see (hopefully I will be able to attach a photo!) that the text at the bottom of the page is smaller than the top. It should really be the other way round. Is there a way to achieve this in the edit page? I am just using the ordinary text tool not the text+ one.

Thanks

Nigel

Re: Help with text please

PostPosted: Sat Oct 17, 2020 12:34 pm
by Jim Simon
Change the Size of the text in those lines.

Re: Help with text please

PostPosted: Sat Oct 17, 2020 1:17 pm
by Nigel Scott
Jim

Thank you. For some reason when I tried that when I started on this a change of text size seemed to affect the whole block. I must have been doing something wrong as no problem now. I then animate the text away from the book page to fill the whole screen so that it is easily read; so now I have to also animate the text size while this happens which is not a problem and the whole thing looks much better.

Thanks again

Nigel

Re: Help with text please

PostPosted: Sun Oct 18, 2020 1:14 pm
by Nigel Scott
Jim I thought that was the solution but it looks like I can't keyframe text size using the basic Text tool so I am going to have to use Text+ after all.