Blackmagic Forum

On17 beta 3 my Fusion works gets not rendered. I can see the vfx perfectly on the Fusion and color page but when I render it out the effect disappears on the render page and obviously it is not there on the rendered file. It is also extremely slow (CPU Load always at 100% and I get only 0.5 or 1fps) It gets rendered at this speed but the output file has no effect applied.

If I prerender it on the edit page (same format as on the render page DNxHR HQX) the fusion effect is applied with no problems and when I finally render out again in the render page everything is fine.
In the render page I render as individual clips.

Testing now...

Yep, it worked with the nodes I was using.

Which are you using? I can test those.

I have send you private message with the node tree.

Did you figure this out? Fusion renders are either corrupt or not showing up at all for me.