Blackmagic Forum

Hi,

Setup to replicate the problem:

—A project with two timelines.
—In Timeline 1: I have a very simple dynamics setup on a track in Fairlight:
1. Audio 1: Send
2. Audio 2: Listen & Apply Compressor.

When I set up the dynamics, it works.

Problem:
—When I switch to the other timeline and come back to the first:
—The dynamics are still set
—But it does not work
—I have to uncheck “listen” and check it again.

The problem also appears when opening the project.

Problem observed in: Beta 3, Beta 4.

I did not check if it was present in previous Beta versions.

Kind regards,
Alexandre Leclerc

Hi,

Just to note that the bug is still present in Beta 5.

The working state of Send/Listen Dynamics are not kept when opening a project of switching between timelines. Even if activated, they are internally not activated.

Best regards.

This is fixed in Studio 17, Beta 7.

Thank you very much!