Possible to use frame numbers yet everywhere instead of time
Posted:
Thu Dec 17, 2020 2:35 pmby Morné Erasmus
Hi Guys
Is it possible yet to set the timecode to frame numbers instead of timing?
Also, could I go to a specific frame in editor by just typing in the frame number?
Re: Possible to use frame numbers yet everywhere instead of
Posted:
Thu Dec 17, 2020 2:56 pmby wfolta
Yes, go to the timecode display above the Edit viewer and right click on it. You can switch it from Source Timecode to Source Frame. You then use frame numbers to jump. You can also right-click on the timecode to the left, which is the length from In to Out (or the entire timeline if no In and Out) and you can switch that to frames as well.
You can click on the field, type in a number then hit Enter to jump. In v16 I think you just type the number on the numeric keypad. In v17 you hit = then type the number. (And hit Enter in both cases.)