Page 1 of 1
Keyframe lowpass filter
Posted:
Sat Dec 26, 2020 6:11 pmby doasilva
Hi,
Does anybody know if it's possible to put keyframes using the lowpass filter? I am looking for put a keyframe at the beginning and another one at the and to cutoff from 13hz and starting going up until 22khz in the end.
Thank you
Re: Keyframe lowpass filter
Posted:
Mon Dec 28, 2020 2:31 pmby Jim Simon
That does not appear to be possible.
Re: Keyframe lowpass filter
Posted:
Tue Dec 29, 2020 2:16 amby Peter Cave
You can use Automation to do this with a VST plugin, but the Fairlight EQ seems to be broken for automation.
Re: Keyframe lowpass filter
Posted:
Tue Dec 29, 2020 6:07 amby Reynaud Venter
Peter Cave wrote:Fairlight EQ seems to be broken for automation.
Track or Clip-based EQ? Only the Track-based EQ module may be automated.
Re: Keyframe lowpass filter
Posted:
Tue Dec 29, 2020 10:12 amby Peter Cave
Reynaud Venter wrote:Peter Cave wrote:Fairlight EQ seems to be broken for automation.
Track or Clip-based EQ? Only the Track-based EQ module may be automated.
Fairlight page, standard EQ module in the mixer.
Re: Keyframe lowpass filter
Posted:
Tue Dec 29, 2020 10:20 amby Reynaud Venter
Peter Cave wrote:Fairlight page, standard EQ module in the mixer.
No issues recording and playing automation data for the Fairlight EQ in beta 6.
Which aspect of the automation system is not behaving on your system?
Re: Keyframe lowpass filter
Posted:
Tue Dec 29, 2020 3:56 pmby Jim Simon
You can Automate the Low Pass frequency, Reynaud?
Re: Keyframe lowpass filter
Posted:
Wed Dec 30, 2020 12:45 amby Peter Cave
Reynaud Venter wrote:Peter Cave wrote:Fairlight page, standard EQ module in the mixer.
No issues recording and playing automation data for the Fairlight EQ in beta 6.
Which aspect of the automation system is not behaving on your system?
I had another look at this and you are correct. I had not clicked on the mixer EQ panel to show the track EQ panel, where I could enable the Band 1 setting.
Thanks.