Blackmagic Forum

Posted: **Tue Dec 29, 2020 2:05 am**

I think I found a new bug in Build 18, for some reason I cannot change the cache locations and have them save as a preset. I have tried 3x now and it just reverts back to the C:\ drive and I discovered it the hard way when I ran out of space on the C:\ drive.

Repro Steps
1. Open DR > Click the gear icon in the lower right corner
2. Go to Master Settings > Working Folders
3. Change the proxy generation location, Cache files location, and Gallery stills location

: WorkingFolders-Location.JPG (20.95 KiB) Viewed 663 times

4. Go to Presets > Save As > Apply > "NewPreset" > OK
5. Highlight the "NewPreset" preset > Load
6. Go back to Master Settings
7. As you can see in the screenshot below, the Working Folders reverts back to the C:\ drive

: WorkingFolders-RevertedBack.JPG (21.83 KiB) Viewed 663 times

Posted: **Tue Dec 29, 2020 4:17 am**

Did you save your project after you made the change?

Posted: **Fri Jan 15, 2021 6:35 pm**

Peter Cave wrote:Did you save your project after you made the change?

Yes, I saved the project and it did not make a difference, it does not save the changed locations.

Posted: **Sat Jan 16, 2021 4:33 pm**

Make sure G: is the first drive listed under Preferences>System>Media Storage.

Posted: **Mon Jan 18, 2021 8:10 pm**

Jim Simon wrote:Make sure G: is the first drive listed under Preferences>System>Media Storage.

It is, been that way since version 16, I haven't changed anything except the version and now it is not working.

Blackmagic Forum

DR 17 Beta Build 18 - Cannot Change Cache Locations?

DR 17 Beta Build 18 - Cannot Change Cache Locations?

Re: DR 17 Beta Build 18 - Cannot Change Cache Locations?

Re: DR 17 Beta Build 18 - Cannot Change Cache Locations?

Re: DR 17 Beta Build 18 - Cannot Change Cache Locations?

Re: DR 17 Beta Build 18 - Cannot Change Cache Locations?