Blackmagic Forum

If I return to project settings sometime after the initial setup, to change something, such as the location of proxy files or to change the frame interpolation settings, when I save the changes and return to the edit page, the Main 1 bus has been changed into Bus 1 and none of the audio tracks are connected to any output bus any more.

If I reboot Resolve the audio usually goes back to showing the Main1 bus and sending all the tracks its way.

If I am working on the delivery page and go to the project settings to change the frame interpolation settings for a render, the same things happen but in addition, any file name I have put in for the render is changed to Untitled.

This has been happening throughout the 17 Beta process.

Also, recently -- I don't know whether throughout the Beta process -- when I start a render on the Deliver Page the In point is changed the moment I hit the render button, to the very beginning of the timeline no matter where I previously set it, and the render begins there. If I stop the render, edit the file to fix the in and out points, then try to render again, it works properly.

Mac OS 10.15.7
Mac Pro trash can 6 core, D700s, 32GB, Resolve 17.0 B6
Tried to send a log but it was rejected as too big. (1.4MB)

On the audio issue, there were fundamental changes under the hood which might explain this. Have you tested a totally new project created in 17?

On the Deliver page issue, changing preferences will (frustratingly) reset your Deliver settings. (Been doing that forever.)

On the In/Out issue:

viewtopic.php?f=36&t=128241

Thanks for this.

Yes, all of the several short projects I've been working on in 17 were started in 17, along with a new database.

Cheers,

Mike