Blackmagic Forum

I'm having an issue when I operate the fullscreen command ctrl f to view my timeline fullscreen, the viewer is going fullscreen but its only showing me a section of the image in fullscreen, any ideas as to what's going on here? The viewer is in 'fit' mode.

What's the resolution of the timeline and the monitor?

Do you have an I/O device attached? (Decklink, or similar?)

i saw this issue while using 'Speed Keyboard' but resizing Davinci Resolve window to fit on window and then use Full View (timeline/source clip) it shows correctly.
Hope this will help for cont+f short key as well.

this is intermittent issue, today again i came across this issue. (no external monitor, no extended display)
simply i switched from timeline to source and again back to timeline and contr+f (full screen) shows correctly

Jim Simon wrote:Do you have an I/O device attached? (Decklink, or similar?)

Nope

md.baseer7 wrote:i saw this issue while using 'Speed Keyboard' but resizing Davinci Resolve window to fit on window and then use Full View (timeline/source clip) it shows correctly.
Hope this will help for cont+f short key as well.

hey, thank you but i'm not quite sure i follow you here?

md.baseer7 wrote:this is intermittent issue, today again i came across this issue. (no external monitor, no extended display)
simply i switched from timeline to source and again back to timeline and contr+f (full screen) shows correctly

When you mean timeline to source and back again, do you mean with the shortcut Q?

SCLDUB123 wrote:Nope

OK.

Is the operating system Display Scaling set to 100% (It should be.)

Jim Simon wrote:

SCLDUB123 wrote:Nope

OK.

Is the operating system Display Scaling set to 100% (It should be.)

Its at 150 ( recommended), but 100 doesn't fix the issue I'm having

Alright.

Keep the Display Scaling at 100%.

Make sure the monitor is connected to your GPU and not the mobo.

Yeah, this was an issue before but that was sorted.

Disregard. Reboot worked.