Blackmagic Forum

Im using davinci resolve 16. I have an adjustment clip over my footage where im adding a glow, camera shake, and a screen pump. Everything works just fine, until i add the transform node for the screen pump. it works fine in fusion, but when i go back to the edit page the image is in the bottom left corner of the viewer. If i try to change the position back in the transform node, it doesnt work. the image is cut to what was visible in the viewer.

Hmmmm.

Move the Transform between MediaIn and Glow.

Your a legend. it worked, thank you for your time do you know why it works like that. just so i can remember better for the future.

Nodes work in a flow chart, one to the next. Seemed most logical that you were wanting to Transform the actual media and not the effects.