Blackmagic Forum

Since installing beta7 I can not get my program to show on my HDMI output of the Intensity Pro 4K I keep getting "out of Range" message on the monitor.

However all display fine when I open edius with the same clips.....

If Edius is also open close Edius as both cannot be open at the same time with IP4K

Thanks John,

Yes, aware of that....only Resolve was open, and I couldn't get it to work...so before mucking around with IP4K settings I thought to try it with Edius Pro X. It works just as it always has... Then I went back and opened Resolve using a project created before beta7....it also works...just new projects created with the beat 7 software are giving the issue...odd

I created a Project today in Studio beta 7 and it outputs fine to IP4K

ArtTistic wrote:just new projects created with the beat 7 software are giving the issue...odd

Just a thought. Are your Beta 7 output settings the same as your earlier projects output settings? Is it possible you have a wide Gamut output setting rather than Rec 709?
Only time I have seen that particular error message was years back with a Sony LCD that could not display 25P timelines.

Here I have not had an issue with beta 7 output to Intensity Pro 4K. I have not updated my BM desktop setting for 4+ years. Old school if it is not broke do not fix it.
Alayne

Old and New projects work fine in beta7 studio with IP4K HDMI output. Sorry I cant help further