Blackmagic Forum

Hi, just wondering if I am approaching this wrong. I am attempting to trim some fader automation which is overwriting the results... Process is as follow.

1. Write first pass automation in touch / snap.
2. Switch to preview mode.
3. Select I/O Range of scene
4. In Latch / Hold.. trim automation down -2db.
5. Auto - Fill range

Instead of my exisiting values trimming down -2db, the value for the entire range is now -2db.

How should I go about achieving a -2db trim across the range?

Thanks,
Matt

Matt.perrott wrote:Fill range

Fill Range writes the current value in to the Range and replaces existing automation data with that value.

Trim Fader Automation (Range not required):
(1) enable Trim
(2) Auto (amber fader)
(3) define the offset value (e.g. -2dB)
(4) engage Transport (amber curve = offset, green = original data)
(5) stop Transport to return to previous automation data

Preview Trim is not currently available in Resolve.