Rendered Output Issue - Flushing
Posted: Tue Feb 02, 2021 12:29 amPosts: 1
Joined: Sun Jan 31, 2021 5:02 pm
Real Name: Tomasz Celkowski
Issue Rendering in Resolve 17
PostSun Jan 31, 2021 5:45 pm
Hi,
I am quite new to Resolve, so perhaps it is just about setting the output parameters right.
I installed version 17 recently and started to edit my travel movie from BC and Alberta. I noticed that two of the drone shots show 'flushes' after rendering. I checked the original, which appears to be fine, but after rendering, you can clearly notice a lot of flashes there and there. I filmed it on GoPro 8 in 4k 30fps. Rendered as original, then even in 1080/720p the outcome was similar. There are the only two shots that I noticed, which show this issue. Other shots, including aerials with increase speed (as these two), are good.
I was wondering if anyone could help.
Much appreciated,
t.
Joined: Sun Jan 31, 2021 5:02 pm
Real Name: Tomasz Celkowski
Issue Rendering in Resolve 17
PostSun Jan 31, 2021 5:45 pm
Hi,
I am quite new to Resolve, so perhaps it is just about setting the output parameters right.
I installed version 17 recently and started to edit my travel movie from BC and Alberta. I noticed that two of the drone shots show 'flushes' after rendering. I checked the original, which appears to be fine, but after rendering, you can clearly notice a lot of flashes there and there. I filmed it on GoPro 8 in 4k 30fps. Rendered as original, then even in 1080/720p the outcome was similar. There are the only two shots that I noticed, which show this issue. Other shots, including aerials with increase speed (as these two), are good.
I was wondering if anyone could help.
Much appreciated,
t.