Blackmagic Forum


https://forum.blackmagicdesign.com/

17b8 Fusion - Custom Tool broken on Image2/3 ?

https://forum.blackmagicdesign.com/viewtopic.php?f=21&t=133927

Page 1 of 1

17b8 Fusion - Custom Tool broken on Image2/3 ?

PostPosted: Mon Feb 08, 2021 10:06 pm
by smunaut
Hi,

Tried using a Custom Tool in Fusion but seems like input Image2 / Image3 are just not working.
Accessing values with `r2` / `r3` / `g2` / ... doesn't work, they are all 0.

Same source working fine for Image1 fails on Image2, so it's not the source formation/data being an issue, it's just like if those inputs were not connected.

Anyone tried this ?


Cheers,

Sylvain


(OpenCL AMD 20.45 Linux 17b8)

Re: 17b8 Fusion - Custom Tool broken on Image2/3 ?

PostPosted: Tue Feb 09, 2021 3:32 pm
by smunaut
I guess nobody uses the CustomTool ?
Or am I the only one for which this is buggy ?

Re: 17b8 Fusion - Custom Tool broken on Image2/3 ?

PostPosted: Tue Feb 09, 2021 6:35 pm
by Jim Simon
smunaut wrote:I guess nobody uses the CustomTool?

Didn't even know there was one.

Re: 17b8 Fusion - Custom Tool broken on Image2/3 ?

PostPosted: Fri Feb 12, 2021 12:51 pm
by smunaut
Seems fixed in b9 fwiw, so nice !