Blackmagic Forum

After creating a transform node in the fusion tab, i go to the modifiers tab of the transform node in order to publish the motion path. More often than not do the controls of the modifier disappear (not always).
I first thought that this only occurs in Fusion standalone, but no... also in 17 build 13.

Build 27 is the current version (Beta 8). Still occurring there?

Thanks Jim

I try to not install every new update; it takes so much time and there is always the risk that other problems occur. But yes maybe I should give it a go.
Was just wondering about other peoples experience.

Best regards, Robert

Jim Simon wrote:Build 27 is the current version (Beta 8). Still occurring there?

I installed Fusion studio 17 build 33........... still the same problem

Update.... Don't mind me; it was a user error, thinking a single click would select the right modifier but it should be a double click.

Wait, are you using Fusion, or the Fusion page in Resolve? (They do have different forums.)

Jim Simon wrote:Wait, are you using Fusion, or the Fusion page in Resolve? (They do have different forums.)

Thank Jim, it turned out to be user error as described above.