Blackmagic Forum

Hello.

I'm not sure but I think I might have found a very strange bug.

On a project where I have a wave file cut into many peaces that has been slowed down by a couple percent.

But after that I noticed that when I tried changing the volumes with key frames the volume under the key framed area didn't change but the volume changes a couple of seconds further down the timeline where the waveform changes.

If I change the speed of the clip back to normal everything is fine again.

Very strange.

Anyone see this anywhere or am I doing something wrong?

Regards

That's weird.

Jim Simon wrote:That's weird.

Yes it is.
I'm guessing this would classify as a bug. Right?

Somehow this problem has mysteriously gone away after a couple of hours of not working on the project.
The PC just sat there with the project opened while I tried the same thing to add key frames and adjust the volume and everything worked as it should.
The key frames adjusted the volume without any problems and the only thing that doesn't work is the waveform doesn't get changed when I change the key frames.
But I left the project open maybe it will be fine tomorrow morning.

Is this with Studio? Maybe the Neural Engine was telling you that you were trying to raise the volume on the wrong part of the clip.

wfolta wrote:Is this with Studio? Maybe the Neural Engine was telling you that you were trying to raise the volume on the wrong part of the clip.

He he. Yeah maybe and it is the studio version.

But it is weird.