REPL in Sourcetape ignores playhead using Editorkeyboard
Posted: Sat Feb 13, 2021 7:19 pmThe replace command (REPL-KEY on the Editor keyboard) is heavily unpredictable when using source tape in the CUT Page
When in Sourcetape viewer it replaces the clip from the start ignoring the playhead position of the source tape viewer.
Sometime it cuts the clip in the timeline at the position of the timelineplayhead, sometime it just replaces the complete clip in the timeline. Sometime it even mixes up clips out of the media pool if they share the same Timecode e.g. coming from Multicam, though not being synced yet. Clips in the media pool are sorted by TC.
When in Source viewer it replaces the entire clip in the timeline, though playhead portions are respected expanding In and Out points of the source starting from the two playhead positions.
Mac, Mojave, DR17B9 Studio Build 33, Editorkeyboard v1.1
EDIT
Codebase Mac DR16.2.8 Studio seems to have the same problem
When in Sourcetape viewer it replaces the clip from the start ignoring the playhead position of the source tape viewer.
Sometime it cuts the clip in the timeline at the position of the timelineplayhead, sometime it just replaces the complete clip in the timeline. Sometime it even mixes up clips out of the media pool if they share the same Timecode e.g. coming from Multicam, though not being synced yet. Clips in the media pool are sorted by TC.
When in Source viewer it replaces the entire clip in the timeline, though playhead portions are respected expanding In and Out points of the source starting from the two playhead positions.
Mac, Mojave, DR17B9 Studio Build 33, Editorkeyboard v1.1
EDIT
Codebase Mac DR16.2.8 Studio seems to have the same problem