Blackmagic Forum


https://forum.blackmagicdesign.com/

Beta 9 - Fusion keyframe window doesn't show all

https://forum.blackmagicdesign.com/viewtopic.php?f=21&t=134408

Page 1 of 1

Beta 9 - Fusion keyframe window doesn't show all

PostPosted: Sun Feb 14, 2021 10:09 am
by deBabba
It's impossible to scroll down to the very bottom of the Keyframe Window in the Fusion tab.

keyfame window too small.jpg
keyfame window too small.jpg (79.03 KiB) Viewed 485 times

The same applies to the content window on the left hand side.

Re: Beta 9 - Fusion keyframe window doesn't show all

PostPosted: Sun Feb 14, 2021 4:30 pm
by Jim Simon
Windows Display Scaling is set to 100%? Sometimes setting that incorrectly can cause GUI issues.

Re: Beta 9 - Fusion keyframe window doesn't show all

PostPosted: Mon Feb 15, 2021 10:20 am
by deBabba
Jim Simon wrote:Windows Display Scaling is set to 100%?


Yes Jim, 100%
It's just a wrong calculation of the window, if I increase the window size vertically to see everything and than come back to the original size it is possible to scroll down to the very bottom.

Re: Beta 9 - Fusion keyframe window doesn't show all

PostPosted: Mon Feb 15, 2021 1:27 pm
by Videoneth
Yeah, I tried it and I got the same problem (when reducing the size of the window)
(I just copy pasted transform nodes just to test it quickly.,. I found another problem doing that)